CHG 1012 Digi-Wave™ 12-Bay Charger
Instructions:
1. Plug the power supply into the AC wall outlet. Plug the power connector into the rear of the CHG 1012 unit.
2. Insert the DLT 100s into the charging slot as illustrated in Figure 1. The unit(s) must be placed in the charger facing forward to
mate with the connectors. A red LED indicator on the DLT 100 will illuminate when charging has started. When the batteries are
fully charged, a green LED is illuminated, indicating the charger is in maintain mode.
You may charge up to 12 DLT 100s per CHG 1012 charger. It will take approximately five hours to fully charge
the batteries.
NOTE: It is safe to leave the DLT 100s in the charger, even after the batteries are fully charged.
Troubleshooting
If no LEDs light up:
1. Check that the power supply is plugged into the AC outlet.
2. Be sure the DLT 100 is facing forward in the charger (see Figure 1).
NOTE: New batteries have various charge conditions, therefore, some batteries may take less time to fully charge.
Charging batteries generates heat. The DLT 100s, charger, and power supply will feel warm when charging. Do not charge
batteries in a closed enclosure, such as a carry case or brief case. To ensure full battery charging, turn off the DLT 100 when
recharging the batteries.
A144
Figure 1: CHG 1012 Digi-Wave™ 12-Bay Charger
