William Sound SPK 024, Руководство по установке и Руководство пользователя, Страница: 6 / 12

6
u
sing the
spk 024 p
owered
s
peaker
˛
s
eleCt a
l
oCation
The SPK 024 can be placed on a table top, shelf or other flat surface in the listening area; or it
can be threaded on to a microphone stand or mounted on a wall or ceiling (see mounting options,
page 7). A power outlet should be accessible and enough space should be available to run wiring
from the audio source to the speaker.
˛
C
onneCt the
p
ower
Select the desired power voltage. Slide the VOLTAGE SELECTOR (see 13, FIG. A) DOWN
for 110-125VAC and UP for 210-240VAC. Plug the AC power cord into an AC outlet and press the
“POWER ON” switch to the ON position. The “ “ power on LED on the front of the unit will
illuminate RED to indicate standby mode.
Note: The supplied AC cable is to be used for 110-125VAC only. A standard European
plug/cable should be used for the 210-240VAC configuration and should be rated minimum
240V, 5A.
S
peaker
p
ower
:
Slide the OFF/AUTO/ON switch (see 5, FIG. A) to the “ON” position to turn the speaker on
(speaker stays on all the time). Or, slide the OFF/AUTO/ON switch to the “AUTO” position to
have the speaker turn on only when it detects an audio signal. The “ “ power on LED on the
front of the unit will illuminate GREEN when an audio source is present.
˛
C
hoose an
a
udio
s
ourCe
˛
Option 1: MIC INPUT
Plug in a dynamic microphone into the 1/4” “MIC INPUT” jack on the back of the speaker. Note:
The SPK 024 DOES NOT supply phantom power for Electret microphones.
Adjust the Microphone Level: First, make sure the master volume control on the front of the SPK
024 is at least 1/4 from max volume. Then rotate the MICROPHONE LEVEL control clockwise
until you hear the broadcast clearly. If the audio input is too low, it will sound noisy. If the input
is too high, it will sound distorted.
˛
Option 2: LINE LEVEL INPUT
Plug in a CD player, tape player, or other audio source into the LINE IN RCA jack on the back of
the speaker.
Adjust the Line In Level: First, make sure the master volume control on the front of the SPK 024
is at least 1/4 from max volume. Then rotate the LINE IN LEVEL control clockwise until you
hear the broadcast clearly. If the audio input is too low, it will sound noisy. If the input is too
high, it will sound distorted.
˛
a
djust
m
aster
v
olume
Rotate the VOLUME control on the front of the SPK 024 until the audio is projecting at a
comfortable listening level.
˛
a
djust
t
one
Rotate the TONE control on the front of the SPK 024 fully clockwise for a flat frequency
response. Rotate the TONE control fully counterclockwise to cut off the high frequencies.