![Wilfa CG-2200 Contact Скачать руководство пользователя страница 30](http://html1.mh-extra.com/html/wilfa/cg-2200-contact/cg-2200-contact_instruction-manual_981431030.webp)
objects or water.
USE :
10.
Different Opening Position :
1)
Closed Position : The Upper plate / cover rests flat on the lower plate / base.
This is your starting and heating position when using as a contact grill or
panini press. It is suitable to bake food with upper and lower dual heating
plates. Put the food into the baking plates and then close the cover, the upper
baking plate / cover can adjust the height based on the thickness of the
different foods.
2)
Open Position : When the upper plate / cover is open , food can be added and
removed. To set the grill to this position, simply lift the upper plate /cover by
the handle until you feel it come a locked position. The cover will stay in the
upright position until you lower the handle for cooking.
3)
Open Grill or Griddle to flat position (180° horizontal position) : when you
begin to cook food, you can grip the black rubber part of the handle and open
the upper baking cover to the jockey position of the hinge gradually, and then
lift the upper plate/cover by handle upward slightly and continue rotate it to
horizontal position, when the upper and lower baking plates are even with
each other, lining up to create one large cooking surface. The grill/Griddle
stays in this position when used as an open grill or griddle.
Picture 1
11.
Cooking Plates Insertion & Removal:
Insertion : Put the frill Griddle into the flat position making sure the controls are
facing front. Insert the plates one at a time. Pls note that each plate precisely fits
the cover or the base of the grill and are differentiated by the words “lower’ or
“upper” stamped on each plate . Grab the lower plate, making sure the cutouts of
the heating element are facing downward. Pls note the drip spout should be on the
front right-hand of corner of the plate if you are facing the grill. Find the plastic
brackets at the center of the housing unit and angle the back end of the plates so
they are parallel with the cutouts on the back of the plates. Then slip the plate
underneath the brackets and push down on the front end of the plate until it snaps