Wildwood E-1 Series, Руководство по эксплуатации и установке

Страница: 17 / 33

17
1. If the burner locks:

Check that the burner inlet is not blocked

Check that the gas to enters properly.

Check that there are no air currents that can disturb the proper operation of the burner.

Check that the air adjustment is not completely closed
2. If the burner does not turn on :
Dirt in form of soot, flour, pizza dough etc. could have dropped in the of vicinity of power devices and
flame detection. For cleaning proceed as follows:

Close the gas tap.

From beneath the burner, loosen the bolts which attach the burner to burner base.

Drop the burner down (taking care not to bend or break power devices and flame detection) and
pull it out through the hole.

Remove any dirt from burner (recommend blowing it with compressed air)

check that the distance from the electrodes burner manifold is correct

Reinstall the burner and secure it properly. If problems persist, contact the customer care center.
3. If the flame is too low:

Verify that the burner is configured with the correct supply type.

Verify nozzle and air gap settings.
4. If the flame is too yellow:

Verify that the air gap B is correct depending on the type of burner configuration.

Possibly increase slightly the air gap B until a flame is ideal when only the upper part of the flame is
yellow
5. If the flame is too light:

Verify that the air gap B is correct depending on the type of burner configuration.

Possibly slightly decrease air gap B.
Troubleshooting
50mm
3mm