Setting up
After camper is safely removed from tow vehicle, proceed
by following these steps.
1) Level camper front to back by placing provided level on
the floor inside cabin and then raising/lowering camper
until the bubble is in the middle. Make the camper just a
little bit unlevel to the back so the condensation from
the AC will drain towards the back of the camper.
2) If camper is unlevel side to side, you may need to ramp
one sides tires on to blocks.
3) Once level, lower the stabilizer jacks using manual tool
provided. An electric impact drill with ¾” Socket works
best (impact not provided). These are for stabilization
purposes only and are not meant to help level the
trailer. The rear jacks will need to sit on blocks.
4) Extend slide once camper is level and stabilized.
