W-AIR Small Business Admin Guide
W-AIR Small Business Admin Guide
Page 5 of 12
1.
2.
3.
press and hold the
button on the back side for more than 2 seconds (LED turns solid
Reset a repeater:
Reset
RED and then GREEN with a double pulsation).
LEDs of the Repeaters
LED blinks green with a double pulse during the first registration process
LED blinks green during the connection process
LED remains solid green when it is registered to a base station
LED blinks green with a fast pulse when a phone connected to the Repeater starts a new call, during the
conversation it blinks red
LED becomes solid red if the Repeater fails to connect to the base station
Double color flashing (red/ green): Repeater is in recovery mode for one of the following reasons (try to re-
assign Repeater to Base station):
Repeater is locked to base/ repeater without repeater mode activated
Sync source base/ repeater not found (Manual mode)
Timeout during RPN allocation due to busy base/repeater
Set up W-AIR Small Business Solution
Step 1. Provision base stations
.
For detailed instruction, refer to
Provisioning of Wildix devices - Admin Guide
Go to menu
of the WMS, click
and provision the gateway. Provisioned base stations appear in the
Devices
+Add
table of Devices.
For Base Station SB the W-AIR Network is created automatically with the default Pin Code 0000” (the Pin is used
to register handsets).
You can change the default PIN code via Custom Provision parameters. Consult the document
Step 2. Register a W-AIR Handset
To register the handset:
Verify that there is only one active W-AIR Network
Go to the handset’s main menu
