EN
20
Maintenance and troubleshooting
The speedE
®
II is maintenance-free and requires no lubrication.
Should the speedE
®
II no longer work, contact an authorised customer
service point for Wiha power tools.
Have damaged parts repaired before use.
Do not correct issues yourself!
State the article number according to the nameplate of your speedE
®
II
for all inquiries and spare part orders.
For additional information regarding the repair and maintenance of your
speedE
®
II, exploded drawings and information about spare parts, visit:
www.wiha.com
Service and warranty
Loss of the nameplate voids all warranty claims!
The nameplate is found on the front lid near the LED lamp.
Customer care
Wiha Werkzeuge GmbH
Obertalstrasse 3–7
78136 Schonach
GERMANY
Tel.: +49 77-22 959-0
Fax: +49 77-22 959-160
Email: [email protected]
Website: www.wiha.com
Technical specifications
li-ion battery
Emissions
Charger
Article number
Order no.
Rated voltage/capacity
Number of battery cells
Max. running time acc. to each
screw fastening case
599001
41914
3.7/1.5 V/Ah
1
around 400 fastenings
Sound pressure level*
Oscillation level**
< 70 dB(A)
< 2.5 m/s²
Article number
Order no.
Charging time
Protection rating
Mains voltage
599002
41915
75 min
2
100–240 V
speedE
®
II
Torque, hard
Torque, soft
Protection class
Idling speed
0.45/1.0 Nm
0.3/0.5 Nm
IP54
280 min -¹
Length x width
(without slimBit)
Length x width (with
slimBit)
Rated voltage
147 x 39 mm
202 x 39 mm
3.6 V
Weight (without li-ion
battery and slimBit)
Weight (with li-ion
battery)
177 g
212 g
* Measured value for noise determined according to EN 62841-2-2. The A-weighted sound pressure level of the power tool is typically less than 70 dB(A). Uncertainty K=3 dB. The noise level during operation can
exceed 80 dB(A). Wear ear protection! Overall oscillation values ah (sum of vectors in three directions) and uncertainty K determined according to EN 62841-2-2: screws: ah<2.5 m/s², K=1.5 m/s².
** The oscillation level and noise emission value were measured according to a standardised measuring method and can be used for comparing power tools with each other.
The value is suitable for a preliminary assessment of the oscillation load. The oscillation level and noise emission value can deviate if the power tool is used for other applications with deviating application
tools or insufficient maintenance. This can considerably increase the oscillation load throughout the entire duration of operation.
A precise assessment of the oscillation load must take into account the times in which the device is shut off or is running but not actually used. This can considerably lower the oscillation load throughout the
entire duration of operation. Set up additional safety measures to protect the user from the effect of oscillation.
For example; maintenance of the power tool and application tools, keeping hands warm, organisation of work processes.
TECHNICAL SPECIFICATIONS
