12
EN
Use
5. Pull the trigger lever (Fig. 1/
9
); the glue flows out of the glue nozzle (Fig. 1/
1
).
NOTE
: If you don't pull the trigger lever, the power will turn off after 2 minutes.
6. To switch the tool off again, press the ON/OFF switch briefly just once.
NOTE
: If 4 red LEDs flash, it means you need to insert a new glue stick.
6.3 Working with the tool
1. You can now apply the glue by pulling the trigger lever (Fig.1/
9
) after the heating-up time.
2. Press both surfaces together immediately and apply pressure to them.
3. It takes about 30 seconds for the glue to set.
4. The tool switches off automatically after approx. 2 minutes of non-use.
CAUTION
: If your gluing work is interrupted or finished, always be sure to stand the tool
on your worktable. You can pull out the stand bar to help the tool stand upright on your
work table as shown in Fig.1. Switch the tool off and allow it to cool down completely before
you pack it away.
NOTE
: Glue stains on textiles cannot be removed.
4VCordlessHotGlueGun-DHT0003-EN-01
