Wiedamark.com | 4016 Harry Hines Blvd, Dallas, Texas 75219 | 800.893.9787
ColorSpot HP 36x1W RGB LEDs, ETL Listed
3. Master/Slave Operation
1. This program will allow all lights that are inter-connected
with DMX cabling to operate in synchronized unison with the
unit assigned as the Master.
2. There can only be one Master fixture. To assign Master
status, follow the instructions for DMX Mode Operation and
assign the DMX address of 001. This will be the Master unit.
3. Assign any other DMX addresses, (with the exception
of 001) to the remaining lights that you want to operate as
Slaves.
4. Interconnect all lights with DMX cabling.
5. Now, whatever parameter you change on the Master unit
with the 001 address, will automatically be mirrored on the
remaining lights.
1. To control with DMX you must assign the light a numeric
3-digit address.
2. Press button “A” until three numeric characters appear on
the display.
3. Now, press the “B” button to increase the value of the
flashing character. Keep pressing “B” until you arrive at the
correct digit.
4. Press “A” to move number selection to the middle character.
Again, use “B” to select the correct digit for your DMX
address.
5. Repeat step 4 again to assign the first digit of your DMX
address.
6. When done, simply wait for the display to stop flashing,
which will confirm it has accepted your DMX address
assignment.
7. Connect the DMX Out from your controller to the DMX In
cable which is located nearest the power cord.
2. DMX Mode Operation
B
A
B
A
