WiebeTech LLC
U l t r a G B U s e r M a n u a l
- 3 -
5)
Drive Installation
.
For users who need to install a 3.5 inch hard drive inside De
Step 1.
Step 2.
Remove two screws holding the back bezel to
the carriage.
Slide the carriage out from the enclosure.
Step 3.
Step 4.
Connect the IDE ribbon cable and power
connector to the drive and place n the carriage.
Secure the drive to the carriage with screws
included.
Step 5.
Step 6.
Slide the carriage and drive back into the
enclosure.
Attach the back bezel to the carriage with the
screws removed in step 1.
6)
FCC COMPLIANCE STATEMENT
.
“This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.”
Many FireWire cables are poorly shielded and as a result are very powerful emitters of Radio Frequency
Interference (RFI). In the event you suspect RFI, we recommend emission suppression ferrites over your
FireWire Cable, using a loop of cable through a ferrite at each end of the FireWire cable. (The cable
receives two ferrites, one at each end of the cable. Each ferrite receives a loop.) Emission ferrites are
available from Radio Shack, with a part number of 273-105.
7)
BUS POWERING.
UltraGB will utilize FireWire bus power, if
adequate
FireWire bus power is
available. In our testing the 80GB and 120GB 5400RPM drives will operate from all computers, including
Apple iBook laptop computers.
Please note: Higher speed 7200RPM drives may be bus powered only
from Apple desktop computers, due to the large power requirements of the drives.
The Power Switch on the UltraGB is 3-position: AC power / Off / FireWire bus power. When attaching
UltraGB to a powered FireWire port, please ensure that the switch is in the center (off) position. After 10
seconds, turn the unit on. This allows time for the internal power storage capacitors to charge up, resulting
in a successful spin up of the drive.
For technical support please contact [email protected].