Wido WD040110036, Руководство пользователя, Страница: 11 / 16

release the switch trigger (See Fig 3).
6. Work light
The screwdriver has a built-in LED work light. This feature is convenient when working in close or tight
areas where additional light is needed.
To turn the work light on, press the light switch once. To turn the
switch off, press the light switch a second time (See Fig 4).
Note: Make sure you turn the light switch off when the work light is not in use to prevent the battery
from being run down.
7. Pivoting handle
To change the pivoting handle to the "in line" position, press and hold the pivoting handle release
button and rotate handle clockwise. Release the button and continue to rotate the handle 180° (See Fig
5). The release button will lock the handle in the "in line" position when the handle is fully rotated 180°.
Reverse these actions to return the handle to the pistol grip configuration.
8. Installing and removing bit
Move forward and reverse rotation control lever to the neutral position. Select an appropriate
screwdriver bit that fits the head of the screw being driven. To install a bit simply insert it into the cavity
in the bit holder. To remove bit, pull straight out (See Fig. 6).
Note: Make sure the screwdriver bit is in good condition and is neither damaged nor worn.
9. Screw driving operation
When driving screws, care must be taken to use the bit that correctly fits the head of the screw being
driven. Make sure to use the largest bit size that will properly fit into the head of the screw. The bit must
also be in good condition and not worn so it will drive screws without slipping out of the screw head.
1) Select the correct screwdriver bit for the screw being driven.
2) Insert the bit fully into the bit holder.
3) Set the rotation direction switch so the screwdriver bit is turning clockwise.
4) Insert the screwdriver bit fully into the screw head.
5) While holding the screwdriver firmly against the screw and the bit aligned with the screw, press the
trigger switch to start the screwdriver and drive the screw (See Fig. 7).
6) When the screw is driven to the correct depth, release the switch. The screwdriver will stop.
7) When the switch is released and the screwdriver stops turning, the spindle will automatically lock.
Fully tighten the screw by manually rotating the screwdriver handle in a clockwise direction.
8) To remove screws, follow the same general procedure as for driving screws.
Note: Make sure that the driver bit is inserted straight in the screw head, or the screw and /or bit may
be damaged.
WORKING HINTS FOR YOUR POWER TOOL
1. Always use the correct type of screwdriver bit.
2. Always hold the power tool and screwdriver bit in a straight line with the screw.
3. If screws are difficult to tighten, try applying a small amount of washing liquid or soap as a lubricant.
4. Before screwing larger, longer screws into hard materials, it is advisable to predrill a pilot hole with
11
3.6V CORDLESS SCREWDRIVER ENG