ADSL Loop Extender Installation Manual Page 13
This publication may neither be reproduced in whole nor in part without the express written
permission of Widearea.
AEC-C2P
Figure 12 The Panel of AEC-C2P
In figure 12, the lights “PWR1” and “PWR2” indicate the status of the equipment. After the power
supply is connected, press the button “K1” and “K2”, and the corresponding PWR light should be
solid green. Flashing indicator indicates short circuits or over-current alarm condition.
5. Installation Procedure
5.1 Unpack
When unpacking the equipment, be sure to check the contents of the packaging for
completeness against your purchase order. Notify your supplier immediately if any items are
missing.
Note: Please save packing material. All equipment returned must be packed in the original
packing material.
Be sure to inspect the equipment for shipping damage, including bent or loose hardware, and
broken connectors. If the equipment appears to have been damaged in transit, please contact
your supplier.
5.2 Install the Power Supply
(1) Generally, the Power Supply is installed at the CO. Make sure the type of power supply you
ordered, AC85V~AC265V or DC48V is correct for your source voltage.
(2) Before installation, the DC 48V or AC85V~AC265V power supply must be reliably
grounded.
(3) The power supply can also be installed in the CPE or near the ALE, if CO installation is not