Whynter T-2C/A, Инструкция по эксплуатации

Страница: 11 / 13

Problems and Malfunctions
If the indicator light on WATERTANK is illuminated red the water tank level is low and
requires topping up.
If the L and START indicator lights flash and the appliance beeps then the Ice Cube Drawer
is not positioned correctly and should be removed and replaced firmly into its recess. There
are a number of sensors associated with the Ice Cube Drawer and the Water Tank and faulty
positioning of these units is the most common cause of malfunction. Always ensure that the
Ice Cube Drawer and the Water Tank are correctly positioned in their recesses.
If the M indicator is illuminated and the appliance beeps, or the M indicator is flashing and
the appliance is not beeping, the ice cube production process is stuck. It may be that ice
cubes are stuck to the freezing element, an ice cube is stuck in the mechanism or the ice
cubes have fused into one large block of ice. If this happen switch off the appliance, unplug it
from the mains electricity, open the Window and leave until all ice blockages melt. Once
everything has melted close the Window, plug the appliance in to the supply, switch it on and
depress START.
In the event of any appliance stoppages, malfunctions or indicator light sequences not
covered in these instructions switch the appliance off for one minute and then switch it on
again. This should clear any spurious faults.
For faults which cannot be cleared and for further assistance and service the contact
information is shown on the next page.