9
Installation and Operation
OPERATING INSTRUCTIONS
1.
Plug the unit into the power outlet. LCD screen will display “00” for standby.
2.
Prepare ingredients (see pages
11
-
12
of the User Manual for recipes). Note:
Please make sure that the pre-mixture does not exceed the top dasher of the
churn
blade to avoid overflowing.
(See 2.a)
3. Place the removable stainless steel mixing bowl into the base and make sure the
bowl is properly aligned. The outside of the stainless steel mixing bowl should be
completely dry before inserting it into the unit.
4.
For ice cream making, place churn blade in the removable stainless steel
mixing
bowl so that it rests in the center of the bowl.
For yogurt making, the
churn blade
is not required for this operation.
2.a
CONTROL KNOB
Ice Cream Mode
-
When
Ice Cream Mode
operation is at a pause
via the Ice Cream Consistency button
, turn the control knob
to increase or decrease the firmness of the ice cream
.
-
When
Ice Cream Mode is in operation, turn the control knob to increase or decrease the operation time
in 1
minute increments. Maximum operation time can be set up to 70 minutes and 5 minutes at the minimum.
Cooling Only Mode
- When in Cooling Only Mode, turn the control knob to increase or decrease the operation time in 1 minute
increments. Maximum operation time can be set up to 70 minutes and 5 minutes at the minimum.
NOTE:
Default operation time is 10 minutes
Mixing Only Mode
- When in Mixing Only Mode, turn the control knob to increase or decrease the operation time in 1 minute
increments. Maximum operation time can be set up to 70 minutes and 5 minutes at the minimum.
NOTE:
Default operation time is 30 minutes
Yogurt Mode
-
When in Yogurt mode, turn the control knob to increase or decrease the operation time in 1 hour
increments. Maximum operation time can be set up to 24 hours and 4 hours at the minimum.
NOTE:
Default operation time is 8 hours.
POWER Button
After the appliance is installed and connected to the power supply, press the Power button to turn the ma-
chine on. The LCD will display “60:00” which is the factory preset 60 minutes operating time. When the unit is
on and the Power button is pressed, the unit will enter Standby mode until the power cord is unplugged.
NOTE: If the POWER Button is pressed at any point of the ice cream making operation, the unit will be turned
off and will automatically reset/cancels the ice cream making process.
ICE CREAM CONSISTENCY
BUTTON
To customize the firmness of the ice cream, press the Ice Cream Consistency Button.
Turn the control
knob to
select the
desired
consistency
. Selection is showed in the display panel with the Ice Cream Consistency
Indicator
bars (
soft, medium
,
and hard).
Press the Start Button
to begin operation.
NOTE:
T
ime
r
starts
at
"00:00"
. This mode
is not controlled by time.
To return to Ice Cr
eam Mode, press .
SPEED SELECTION BUTTON
After selecting Ice Cream mode or Mixing Only mode, the speed can be adjusted
by pressing the Speed
Selection Button. The mixing speed can be programmed from low, medium, and high speed. Selection is
showed in the display panel with the Speed Indicator bars
NOTE:
Speed selection cannot be controlled by the control knob.
START / PAUSE Button
Press the START/PAUSE button to initiate operation. The LCD will display the operation icon corresponding
to
the operation mode chosen. The unit can be paused by pressing the START/PAUSE again. At pause,
press
START/PAUSE button and the
ice cream maker
will resume its unfinished
operation.
NOTE:
The unit may enter a three minute compressor lockout when operation of the unit has been resumed.
This three minute time delay helps extend the life of the compressor. During the compressor lockout, the
Mixing icon will be
flashing while the Ice Cream icon is displayed
. Once delay elapses, the compressor will
engage,
I
ce
C
ream icon will be
flashing
, and the ice cream maker will start cooling again.
