Whynter ARC-148MHP, Инструкция по эксплуатации

Страница: 16 / 19

16
CARE AND MAINTENANCE
IMPORTANT:

Switch off the air conditioner and disconnect the plug from
the power outlet

Drain water by removing the drain plug

Always transport the air conditioner in an upright position
only
CLEANING THE AIR FILTERS

To ensure the air intake is filtered properly and to assure
that your air conditioner runs efficiently, it is recommended
to clean the air filters at least once every two weeks

This unit has three air filters; the Silvershield pre-filter, 3M
filter and the lower air filter

Switch off the air conditioner and remove the Silvershield
pre-filter and 3M filter from the unit (Fig. 7a and Fig. 7b)

Remove the lower filter by loosening the screw and taking
down the air inlet grille. (Fig. 7a)

Use a vacuum cleaner or tap lightly to remove loose dust
and dirt from the filters. Then rinse them thoroughly under
warm or cold running water (no hotter than 100F.)

Dry thoroughly before re-inserting the filters. (Fig. 7c)
NOTE: Silvershield pre-filter is washable and does not
need to be replaced. The 3M should be replaced every 2-3
months depending on usage. Please contact
info@whynter.com for retail sales information
WARNING! Never operate the air conditioner without the
filter in place
CLEANING THE AIR CONDITIONER

Always switch off the air conditioner and disconnect the
plug from the power supply outlet before cleaning the air
conditioner

Use a soft damp cloth to wipe the body of the unit.

Never use harsh chemicals, oil-based products, deter-
gents, chemically treated cloths or other cleaning solutions.
These could possibly damage the body of the air condition-
er
END OF SEASON STORAGE

Switch off the air conditioner and disconnect the power
plug from the power supply outlet before cleaning the air
conditioner

To remove the hose from the unit, the easiest way is to
remove take out the hose and leave the connector in
place.

Clean the air filters

Drain the condensed water completely

On a warm day, turn on the Fan only mode for half a day
so that the inside can dry out completely

Remove the batteries from the remote controller

Wrap the cord using the Power Cord Buckle and insert the
plug into the Power Plug Socket. (Fig. 7d)

It is recommended that the air conditioner be put back into
its original carton for storage
The Silvershield pre-
filter can be removed
for cleaning by pull-
ing the filter frame
back and out
Remove the screw,
then remove the lower
air filter
Install the Silvershield
pre-filter and filter frame
back to its place
Re-install lower air
filter and screw
Fig. 7a
Fig. 7b
Fig. 7c
Fig. 7d
Power Cord
Buckle
Power Plug
Socket
3M Filter