1448AFGSPa; 1448AFCAFa Pacific Queen Storage Bed
Assembly Instructions
This assembly requires two people.
1448AFGSPa_1448AFCAFa
— Page 7 — 04/13
7.
Position the Headboard (A) against the end of the pedestal assembly. Place four 5/16" Washers
(E) over four 5/16" x 2-1/4" Hex Bolts (D) and thread the washer/bolts through the predrilled
holes in the Pedestal Assembly and into the Headboard. Tighten the bolts with a 1/2" wrench.
See Figure 7.
8.
Secure the pre-attached Angle Brackets (K) on the Headboard to the Pedestal Assembly with
six #6 x 3/4" Flat Head Screws (L). See Figures 8 and 8a. Insert one Barrel Nut (I) into the pre-
drilled holes on the bottom of the left pedestal rail. Using a slotted screwdriver, line up the hole
in the Barrel Nut to the hole in the Headboard. Insert one 1/4" x 80mm Hex Bolt (F) into the pre-
drilled hole in the Headboard and tighten with the provided Hex Wrench (S). Repeat for the right
side. See Figures 8 and 8b.
Fig. 8
F
I
x 2
x 2
L
x 6
L
F
K
I
F
Fig. 8b
Fig. 7
E
D
E
x 4
x 4
D
