74"W McKenzie 2-Drawer Center Channel Console
Assembly Instructions
2084GAC_2084CAF — Page 4 — 04/16
Tool Required: Phillips Screwdriver, Pencil.
1.
Place the console at its final destination. Rotate the Adjustable Glides (ZJ) found at the corners
of the unit and (ZI) at the bottom of the Center Foot until the unit is level. See Figure 1.
2.
Two Wood Door Panels (G) have been included as an optional replacement for the Door Glass
(F).
To install the optional Wood Door Panels (G), remove the doors from the unit and place
them face down on a clean, protected surface.
DO NOT LEAN ON THE GLASS AT ANY TIME.
Remove the screws from the Door Glass Support Rails (H) and Door Glass Support Stiles (I)
and carefully remove Door Glass (F). See Figures 2 and 2a. Place the good face of the Wood
Door Panels (G) within the Door Frames (E) face down and reattach the Rails and Stiles with
the #6 x 3/4" Flat Head Screws (Q). See Figure 2b. Reattach Doors to the Media Console. See
Figures 2, 2a, 2b.
Fig. 2
Fig. 2a
Q
Q
x 12
I
I
H
H
F
E
x 2
x 2
Fig. 2b
Q
I
I
H
H
x 2
Fig. 1
ZI
ZJ
ZJ
