1186RGBa 9-Drawer Stonewood Dresser
Assembly Instructions
1186RGBa — Page 9 — 10/16
8.
Decide where you want to place the piece of furniture in your room. Mark the baseboard with a
pencil mark directly behind the location where the tipping restraint is attached to your item.
Move the item away from the wall far enough to allow you to access the spot where the
baseboard meets the floor. Position the Straps (C) and Plastic Bracket (B) as shown in Figures
8 and 8a with the angled corners of the Plastic Bracket (B) firmly placed against the seam of the
baseboard and floor. Attach by driving #8 x 3" Pan Head Screws (E) through the holes in the
Plastic Bracket (B) into the seam below the baseboard where it meets the floor. See Figures 8
and 8a.
9.
Move the item back into position against the wall and reach underneath the piece of furniture to
grasp the loop in the free end of the strap. Pull the free end of the Strap (C) until portion
between the Plastic Bracket (B) that you have attached to your wall/floor and the one at the
back of the item is tight. See Figures 9 and 9a. If you need to move the piece of furniture reach
beneath and locate the buckle which connects the two sections of the strap and depress the
release lever, then pull on the section of strap that is between the buckle and the back apron of
the furniture until there is enough slack to allow you to pull the item away from the wall.
Fig. 8
E
x 2
Wall
Floor
Fig. 8a
Baseboard
Top
Back
Side
E
Floor
Wall
B
Fig. 9a
Fig. 9
C
Wall
Floor
B
