2091AFGSPc; 2091AFCAFc 64"W Pacific Sound Bar Console
Assembly Instructions
2091AFGSPc_2091AFCAFc
— Page 6 — 10/13
3.
To open the Speaker Door (Ga), simultaneously press the Push Plates or both corners until the
magnets release. Gently grasp the middle of the door and pull it open. To shut the door, push
gently but firmly on the Speaker Door (Ga) until the two Tuscan Magnetic Plates (YI) make
secure contact with the Magnetic Push Locks (Q).
If you did not install the Push Plates, gently press on both corners until the magnets release.
See Figure 3.
If you need to install your sound bar from the back, remove the #6 x 1/2" Philtruss Screws (W)
and pull away the fitted back (ZT). After installing the component, replace the Fitted Back and
attach with the #6 x 1/2" Philtruss Screws.
4.
If your center sound bar needs to sit above the edge of the speaker door, place the two Speaker
Spacers (ZU) into the sound compartment so the Velvet Pads (ZV) face down. Place the
speaker on top of the Spacers. See Figures 4 and 4a.
Fig. 4
Ga
ZU
ZU
Fig. 4a
ZU
Fig. 3
YI
ZT
Q
Ga
Q
YI
