2. EZ MOUNT SYSTEM
7.
From underneath the sink, slip fiber gasket (see 1)
onto exposed sink flange. With arrows pointing up, screw
support ring (see 2) onto the sink flange, hand tighten
until the sink flange will not move (see photo H). At this
point you may want to insert stopper in sink and fill with
water to check sink flange seal and ensure there are no
leaks.
8.
Place mount ring (see 3) over sink flange and hold in
place while installing cushion mount (see 4) (large side
down) so the groove on the inside of cushion mount fits
over lip on sink flange, similar to putting the lid on a
plastic container (see photo I, J and K).
H
I
J
K
CUSHION MOUNT DETAIL
3
1
2
3
4
When the cushion mount is installed correctly, the lip of the sink flange fits into the groove on
the inside of the cushion mount and mount ring can be pulled downward over cushion mount
and will be free to rotate. The bottom bead of the cushion mount acts as a gasket between the
bottom of the sink flange and the top of the disposal. See photo D.
IMPORTANT NOTICE: CUSHION MOUNT DETAIL
