WHITEHALL MANUFACTURING
• P.O. BOX 3527 • City of Industry, CA 91744-0527 U.S.A
Phone (800) 782-7706 • (626) 968-6681 • Fax (626) 855-4862 • Web: www.whitehallmfg.com
6
There is rusting on the inside of my Water Bath tank.
Some form of "ferrous" (iron-containing) metal object
may have come into contact with the tank. Inspect the
inside of the tank. Determine if some form of metallic
object such as a staple, metal paper clip, safety pin, etc.
has fallen into the tank. If so, remove the object and
thoroughly clean the affected area of the tank. If rusting
persists after foreign object has been removed and tank
has been thoroughly cleaned, use a rust remover on the
affected area. Rust remover must be safe for use on
stainless steel, such as CRES Cleaner. (CRES Cleaner
is available through Whitehall.) Be sure to follow rust
remover instructions.
TROUBLESHOOTING FOR TEMPERATURE CONTROLLER
INDICATION
PROBABLE CAUSE
CORRECTIVE ACT ION
- The thermostat is broken.
- The thermostat is set too low.
- Replace the thermostat.
- Adjust the thermostat.
- Adjust the thermostat.
- Replace the thermostat.
- The thermostat is set too high.
- The thermostat is broken.
Splint material too hot.
- The ON/OFF switch is broken.
- Replace the switch.
- Turn on the circuit breaker.
- Replace the thermostat.
- Replace the heating
element.
- Circuit breaker is off.
- Thermostat is not working.
- Heating element is
burned out.
is ON.
plugged in and switch
even though unit is
Water doesn't get hot,
Splint material too hot &
then too cool.
- The thermostat is broken.
- Replace the thermostat.
Splint material too cool
and will not form.
- The Over Temp Sensor
is burned out.
- Replace Over Temp Sensor.
- Power to unit may be off.
No power. Appears dead.
- Check switch.
- Fuse may be blown. Breaker
- Check fuses and breakers.
may be tripped.
- Wiring may be open. Input
- Check for bad connections.
power may be incorrect.
FAQs
(Frequently Asked Questions)
& TROUBLESHOOTING
(continued)
The water in my Water Bath is becoming too cloudy.
The water inside the tank has not been replaced in quite
a while or has become contaminated.
Drain the existing water, clean the tank and refill with
clean water. Be sure to follow instructions on how to
empty the appliance by referring to the
EMPTYING
YOUR WATER BATH
section of this manual. Be sure to
follow instructions on how to clean the appliance by
referring to the "
CARE & CLEANING…
" section of this
manual.
--------------------------------------
Instructions for Operation and Care of Water Bath SP-1600-A-220
