Height
mm
Width
mm
Weight
kg
765mm
375mm
7.7
SPECIFICATION
The Cygnus SX is a IP65 exterior lighting product.
Driver
Enclosure
Each Cygnus SX luminaire is shipped in one
single package:
Before commencing installation, check
contents of all carton to ensure that all
components are present and in good
condition.
1) Main body and head
2) Ip65 terminal connection block
INSTALLATION SEQUENCE
In order to fit this luminaire, the correct
sequence of assembly must be observed.
1. Remove the fitting from its
packaging along with the IP65
Terminal connection block,
(fig 1).
2. Take a 3 core cable (diameter=
9:12mm, 1.5mmsq core) and
push through the grommet,
(fig 1).
3. Take the connection terminal
block and wire the live, neutral in
and the earth into the remaining
terminal connection point, (fig 2).
4. Then push the connection
terminal block into the grommet
till it clicks, (fig 3).
5. Tighten the stuffing gland so that
the cable is secure. (caution
must be taken not to drop
stuffing gland as it can be difficult
to recover.)
6. Take both sides of the
connector and push together,
(fig 3).
7. Pull cover up and twist until the
small knobs click into place,
(fig 4).
7. Loosen the screws at the bottom of
the base of the luminaire, (fig. 5).
8. Slot the head of the luminaire on the
top of the post making sure that it fits
with a maximum width of the post top
being 60mm, (fig.5).
9.
Tighten the screws so that the head
of the fitting is securely fastened to
the pole with a force of 6 Nm.
10. Make sure the head is secure on the
top of the post.
Fig. 7
Fig. 4
Fig. 5
Fig. 6
Specification
765mm
375mm
Fig 5
