7
INSTALLATION
1.
To ensure adequate ventilation for your
refrigerator, it is recommended to pro-
vide space of 60mm on both sides and
at the back, and space of 90mm above
the refrigerator. Insuffi cient spacing will
decrease cooling effi ciency, increase
energy consumption and may reduce
the life of the unit (see page 3).
2.
Using the two front adjustable feet,
ensure that the refrigerator is posi-
tioned fi rmly and level on the fl oor.
3.
Using the adjustable feet, raise the
front of the unit so it leans back slightly,
this will assist in door closing. Make
fi nal adjustments to ensure that the
doors are correctly aligned.
4.
Remove the 4 screws from the bottom
of the refrigerator and use these to fi t
the kickplate (supplied inside the
refrigerator compartment).
5.
Connect the power plug to a 240 volt
10 amp power point.
NOTES:
• Position your refrigerator so that the plug is
accessible.
• Keep your refrigerator out of direct sunlight.
Adjustable feet
When the left
door is raised
When the right
door is raised
Lower the foot
at right side*
Lower the foot
at left side*
*Until the adjustable foot on the
other side is slightly off ground.
Screw
(4 screws)
Screw
Kickplate
• Do not place next to a heat generating
appliance.
• This refrigerator is designed for indoor use
only – do not place the unit on an unsealed
surface.
• To avoid vibration and misalignment of the
doors, the unit must be level. Place the unit
on a solid fl at surface.
• Uneven
fl oors eg. slate, tiles and fl oor-
boards, can cause the unit to sag over time
causing the doors to become misaligned.
• If the mains power is switched on when
the door is open, the door alarm will sound.
Close the door to stop the alarm.
When transporting
Wipe up water in the evaporating pan.
Before wiping up the water, wait more than
1 hour after pulling out the plug because
refrigeration cycle equipment is extremely
hot. (The evaporating pan is located at the
rear of the product.)
Evaporation pan
• Using the rollers, it is possible to move
back and forth. Carry the refrigerator by
holding the holding devices located on
the rear and bottom.
Before using your refrigerator
• Clean the inside parts with a cloth
soaked in warm water. If soapy water is
used, wipe it off thoroughly.
