22
Jump Starting
WARNING:
Never jump start a damaged or
frozen battery. Be certain the vehicles do not
touch, and ignitions are off. Do not allow cable
clamps to touch.
•
Connect positive (+) cable to positive post (+) of
your tractor’s discharged battery.
•
Connect the other end of the cable to the (positive
+) post of the jumper battery.
•
Connect the second cable (negative –) to the other
post of the jumper battery.
•
Make the final connection on the engine block of
the stalled tractor, away from the battery. Attach to
a unpainted part to assure a good connection.
IMPORTANT:
If the jumper battery is installed on a
vehicle (i.e. car, truck), do NOT start the vehicle’s
engine when jump starting your tractor.
•
Start the tractor (as instructed on page 14).
•
Set the tractor’s parking brake before removing the
jumper cables, in reverse order of connection.
•
Allow the tractor’s engine to run for 15 minutes
before shutting it off to allow the alternating system
time to charge the discharged battery.
Charging
If the unit has not been put into use for an extended period
of time, charge the battery with an automotive-type 12-volt
charger for a minimum of one hour at six amps.
WARNING:
Batteries give off an explosive gas
while charging. Charge battery in a well ventilated
area and keep away from an open flame or pilot
light as on a water heater, space heater, furnace,
clothes dryer or other gas appliances.
Cutting Deck Removal
To remove the cutting deck, proceed as follows:
•
Place the PTO/Blade Engage knob in the
disengaged (OFF) position and engage the parking
brake.
•
Lower the deck by moving the deck lift lever into the
bottom notch on the right fender.
•
Remove the deck belt from around the tractor’s
electric PTO clutch (refer to
Changing the Deck Belt
).
•
Looking at the cutting deck from the left side of the
tractor, locate the deck support pin on the rear left
side of the deck.
•
Rotate the pin slightly toward the rear of the tractor
and release the pin into the hole provided.
•
Pull the deck support pin outward to release the
deck from the deck lift arm. See Figure 17.
Figure 17
•
Repeat the above steps on the tractor’s right side.
•
Move the deck lift lever into the top notch to raise
the deck lift arms up and out of the way.
•
Gently slide the cutting deck toward the front of the
tractor allowing the hooks on the deck to release
themselves from the deck stabilizer rod.
•
Gently slide the cutting deck (from the right side)
out from underneath the tractor.
Changing the Deck Belt
WARNING:
Be sure to shut the engine off,
remove ignition key, disconnect the spark
plug wire(s) and ground against the engine to
prevent unintended starting before removing
the belt(s).
WARNING:
Avoid the possibility of a
pinching injury. Do not place your fingers on
the idler spring or between the belt and a
pulley while removing the belt.
All belts on your tractor are subject to wear and should
be replaced if any signs of wear are present.
IMPORTANT:
The V-belts found on your tractor are
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. For a proper working machine,
use factory approved belts.
To change or replace the deck belt on your tractor,
proceed as follows:
•
Lower the deck by moving the deck lift lever into the
bottom notch on the right fender.
•
Remove the belt guards by removing the self-
tapping screws that fasten them to the deck.
S
upport Pin
Содержание GT 954H
Страница 27: ...27 NOTES ...
Страница 42: ...42 NOTES ...