16
Figure 9
Seat Adjustment
WARNING:
Before operating this machine,
make sure the seat is engaged in the seat
stop, stand behind the machine and pull back
on seat until fully engaged into stop.
To adjust the position of the seat, move the seat
adjustment lever to the left and slide the seat forward or
rearward. See Figure 10. Make sure seat is locked into
position before operating the tractor.
Figure 10
Parking Brake Adjustment
WARNING:
Never attempt to adjust the
brakes while the engine is running. Always
disengage PTO, move shift lever into neutral
position, stop engine and remove key to
prevent unintended starting.
If the tractor does not come to a complete stop when
the brake pedal is completely depressed, or if the
tractor’s rear wheels can roll with the parking brake
applied, the brake is in need of adjustment. The brake
disc can be found on the right side of the transmission
in the rear of the tractor. Adjust if necessary as follows:
•
Looking at the transmission from the right side of
the tractor, locate the compression spring and
brake disc. See Figure 11.
Figure 11
•
Loosen, but do NOT remove, the hex nut found on
the right side of the brake assembly. See Figure 11.
•
Using a feeler gauge, set the gap between the
brake disc and the brake puck at .011".
•
Re-tighten the hex nut loosened earlier.
Jam
Deck
Stabilizer
Bracket
Nuts
Lock
Nuts
Deck
A
B
FRONT TO REAR
SIDE TO SIDE
Hex Cap Screw
Adjustment Gear
Seat Adjustment Lever
Brake Disc
Hex Nut
Compression
Spring
Set Gap
at .011"
NOTE:
View shown from beneath tractor.
Transmission
