6
PREPARATION FOR USE
The transportation board is made from expanded polystyrene. Remove the adhesive tapes from
sides, lift the refrigerator up and take out the board.
When positioning the appliance in chosen location, it will move more easily into position if you lift the
front a little and incline it backward, allowing it to roll on its casters.
Strip sticky tape off and open the doors. Remove the red transportation holders from the shelves.
◄
If your appliance is supplied complete with
glass shelves, pull a shelf in the direction
1
and
remove each red transportation holder in the
direction
2
.
Take two supports
1
from the pack and insert
them into the guides
2
in the back part of the
table
top.
►
Adjusting the feet, mount the refrigerator with a slight backwards incline to provide a self closing door
effect.
It is very important that all the feet are uniformly touching the floor.
LOCATION
•
The fridge freezer should be placed in a dry, well ventilated room.
•
The fridge freezer must be kept from exposure to direct sun rays.
•
It is not advisable to locate it near the heat sources (boilers, radiators and so
on). If it is not possible to select another place, use an insulating panel.
•
The appliance must not touch heating, gas or other pipes or heating
devices.
Overall space required in use of the refigerator.
►
If the appliance is placed in a corner, a gap of at least 1 cm must be left between
the appliance body and the wall so that the freezer compartment door can be
opened enough to pull out the frozen product drawer.
VENTILATION
IMPORTANT!
Keep ventilation openings
in the appliance enclosure or in
the built - in structure, clear of obstruction.
◄
Do not cover the ventilation holes at the top of the appliances– it must be a
good air circulation around the appliance. There should be a gap of at least 10
cm between the top of the appliance body and any furniture that may be above
it. If this requirement is not followed, the appliance consumes more electrical
energy and its compressor may overheat.
If doors of the appliance close badly, it is necessary to change the door gasket.
If the door does not close correctly, the temperature in the appliance rises and
energy consumption increases.
