ADDITIONAL INFORMATION
Many outlets sell “universal” tumble dryer accessories. These may not fit satisfactorily and could impair the
efficient operation of your tumble dryer and may even cause air-flow restrictions not covered by our guarantee.
Crosslee always obtains test house approval for dryer accessories so use this order form to obtain genuine authentic
accessories.
INSTALLATION
Position the tumble dryer so that the plug remains accessible after installation. Do not block the vent at the side or
base of the dryer, as this will impair the working of the machine. This appliance must not be installed behind a
lockable door, a sliding door or a door with hinges on the opposite side to that of the tumble dryer.
TUMBLE DRYER VENTING
Your tumble dryer may be supplied with a vent hose (If not, one is available as an accessory).
A vent hose allows you to direct the warm, damp air expelled from the rear of the dryer to an open door or
window.
The best solution is to make a permanent connection through either a wall or a window. This is particularly
recommended for small, cool rooms and a kit for this purpose is available as an accessory.
When using a vent hose, remember the following points:
The vent hose must be at least 10cm (4 ins) in diameter.
No more than three right-angled bends should be allowed when positioning the vent hose.
Do not distort or constrict the vent hose as this will reduce the airflow.
When drying, the vent hose must always be extended to an open door or window.
The vent hose must not be shared with other appliances, for example, a cooker hood outlet.
Note:
Do not obstruct or add a mesh to the vent hose outlet during use and ensure that it cannot be blocked
or bent sharply which may obstruct the airflow.
It is recommended that the interior of the hose be periodically inspected and cleaned if necessary.
FINAL INSTALLATION
Push the filter into its operating position as shown in the
diagram. Remove any dust by wiping the drum and door with
a damp cloth. Any initial smell of burning will be caused by
dust on the heater and will quickly disappear.
THE CONTROLS
A. THE TIMER
Turn the timer knob fully clockwise before selecting
the required drying time based on the
recommendations on the control panel.
B. HEAT SWITCH
Select the required heat setting based on the recommendations on the control panel.
