White Knight 44A7S, Инструкция по эксплуатации

Страница: 6 / 12

OPERATION
Open the door.
Load clothes loosely into the drum.
Load sheets first, starting with one corner.
Close the door.
Dry your hands.
Check that the timer is in the ‘0’position.
Plug in the machine.
Select correct heat position, (see programme chart on control panel for recommendations).
Set the timer to the required time setting (see programme chart on control panel for recommendations).
For energy labeling purposes (EN61121:2005) for a cotton dry load, use the maximum load weight for cotton and
set the timer to the recommended drying time for cotton dry as specified on the control panel.
Press the start button if fitted.
The drum will begin rotating. Reversing drum models will stop periodically to rotate in the reverse direction for a
short time.
Should the clothes become dry before the cycle has finished, or if an excessive programme time has been selected,
the drum will continue to rotate while the thermostat will automatically regulate the heater to reduce the risk of
over drying.
If the door is opened during a cycle the dryer will stop. To restart, close the door and press the start button (if
fitted).When drying large items such as sheets, we suggest you periodically stop the dryer to redistribute the load,
and restart it immediately afterwards.
There is an automatic 12 minute cool down period at the end of every cycle, during which the heater is switched
off. This helps to minimize creasing, and must always be used fully to avoid the risk of fire.
The final part of a tumble dryer cycle occurs without heat (cool down cycle) to ensure that the items are left at a
temperature that ensures that the items will not be damaged.
NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM. RISK OF FIRE.
ALWAYS CLEAN THE FILTER AFTER EACH USE
. Failure to do so could cause the safety cut-out to
operate.
- Pull the filter upwards and away from the appliance.
- Remove any threads or fluff by hand or with a soft brush.
- Slide the filter back.
- Wash the filter occasionally in detergent solution using a soft brush to
remove small particles.
- If your filter becomes damaged, replace it to ensure no damage is caused to
the dryer.