6
RECOMMENDATIONS FOR DISMANTLING
Note:
Re-assembly should be done in reverse
sequence to these instructions.
HEATER ASSEMBLY REMOVAL
Heater Assy. (32), Solenoid Coil (45 or 45A), Flame
failure Electrode (33), lgnition Electrode (39).
Withdraw the 2-screws securing the Plinth (199) to the
Cabinet, unhook the bottom edge fixing, and remove it.
Separate the 4-way Housing (31 ) to release the wiring
from the Heater Assy. to the Cabinet.
Lay the dryer flat on its front, supported to take the
weight from the door and controls.
Withdraw the 6-screws securing the Cover Piate (19) to
the Back Panel (24) and remove it. Pull out the Exhaust
Tube (30).
Withdraw the 4-screws securing the Hot Air Elbow Assy.
(20) to the Back Panel (24) and remove it.
Disconnect the External Feed Pipe (15) from the Tee
Piece (27).
Pull the connectors off the Flame failure Electrode (33)
and the ignition Electrode (39).
SERVICE INSTRUCTIONS
Heat
Heat
Содержание 43A
