Whisper Power 41001105, Руководство пользователя

Страница: 17 / 32

MAINTENANCE
M-GV/2, M-GV/3, M-GV/3+, M-GV 8, M-GV 10, M-GV 12 and M-GV 15 Ͷ May 2018 Ͷ EN
17
5 MAINTENANCE
5.1 MAINTENANCE INTERVALS
Service level break-in 1 2 3 4
before
each
start
after
35-50 h
every
200 h/
6M*
every
400 h/
12M*
every
800 h/
24M*
every
1600 h/
36M*
Lubricating oil check oil level
z
change oil and oil filter cartridge
z z
(12M)
check lubricating oil pressure
Cooling
system check cooling liquid level
z
check and clean radiator (if installed)
z
replace water pump impeller
z
check hoses
z
check cooling system
z
/
Exhaust check exhaust
z
Nuts & bolts check all and tighten where necessary
z
Electrics check all electrical connections
z z
check/adjust V-belt tension
z
check battery (acid level, connections)
z
Fuel system drain water from tank
z
replace fuel filter
z
check fuel hoses
z
check injection nozzles and injection pressure
check injection pump
(3200h)
Air supply check air strainer and filter element
z
Cylinder head retighten cylinder head bolts and readjust valve
clearance
z
/
* Whichever comes first.
z
Can be done by user. Corrective action to be taken whenever necessary.
WhisperPower service centre to be contacted.
5.2 ALTERNATOR
The alternator does not require maintenance.
5.3 ENGINE
5.3.1 Preliminary instructions
The first service on the engine should be carried out after 50
running hours. This period also applies after a major overhaul.
During the first 50 hours, the engine should receive special
attention:
x
Long periods of light or no load running in the first 50
hours may lead to cylinder glazing and high oil
consumption.
x
For the same reason it is of the greatest importance to use
the right oil specification.
5.3.2 Bleeding the fuel lines
When the engine is started up for the first time or after it has
run out of fuel, the fuel system may need to be primed. Push
the start button activating the electric system and activating the
fuel pump. When more time is needed to bleed, hold the
͞^ƚĂƌƚͬ^ƚŽƉ͟ ďƵƚƚŽŶ ŽŶ ƚŚĞ ůŽĐĂů ĐŽŶƚƌŽů ƉĂŶĞů ;ƐŽ ŶŽƚ ŽŶ ƚŚĞ
remote panel). While the button is held, the pump will work,
but the unit will not start. Hold as long as necessary to bleed
the system
5.4 REGULAR MAINTENANCE
5.4.1 General precautions
All regular maintenance can be carried out when the enclosure
is open. When oil and dirt have gathered in the enclosure,
measures have to be taken to prevent oil from being spilled.