WHISKY PARTS Co / 6400 W 105th STREET / BLOOMINGTON MN, USA 55438 / 1.877.774.6217 / [email protected] / whiskyparts.com/safety
19239 09/16 | 85-000583-INST_A
10.
Check that assembly is properly tight.
11.
Install fenders per fender manufacturer’s specifications.
NOTE:
Whisky recommends breakaway fenders only!
12.
An M5 screw will need to be used to mount fender crown hardware
to fork.
Ongoing Maintenance
Periodically check to make sure all mounting bolts are properly tightened to
the frame, and that the fenders are properly tightened and installed per the
fender manufacturer’s specifications.
Fork-Mount Bicycle Racks
1.
When using a fork-mount (axle
dropout-clamping) bicycle rack,
always ensure the clamp is closed
securely to prevent dropout and/or
bike damage. If the clamp is set
too loosely the bike can fall out
of the rack.
2.
When removing the fork from
the clamping device make sure
to pull/push straight up allowing
the dropouts to be removed
evenly and at the same time.
Do not tilt the bike to remove it
from the clamping device,
as dropout damage can result
(figure 7).
WARNING:
Dropout damage can cause component failure, which can
result in serious injury.
Ongoing Maintenance
WARNING:
Do not modify the fork, other than cutting the steerer tube
to the correct length for your bicycle. Modifying the fork could cause fork
or other component failure resulting in serious injury.
1.
Loosen the stem’s steerer clamp bolts before making any stem-to-fork
alignment adjustments.
2.
Periodically remove, clean, and inspect your fork for damage, cracks,
or any other signs of premature wear. Any questions about marks
or cracks on the fork should be directed to your Whisky Parts Co.
dealer immediately.
3.
In the event of a crash or impact, carefully inspect handlebars, fork, stem,
seatpost, wheels, and the frame for any visible damage. As with any
component under varying degrees of stress there is a fatigue life that is
proportional to the type of use and abuse applied to the part. Always inspect
your components before a ride. If you have doubts about the integrity and
condition of any part, replace it. Consult your dealer if you are unsure about
the condition of your components or any part of your bicycle.
Warranty Registration:
Proof of purchase is required before a warranty claim is processed.
Whisky Parts Co. therefore strongly encourages warranty registration at
whiskyparts.com. Failure to register will not affect consumer rights under
the limited warranty, so long as the consumer can show in a reasonable
manner proof of original ownership and the date the Whisky Parts Co.
product was purchased.
If you have any questions contact [email protected].
7
