4.2 Spinner Dome Installation
Install the spinner dome onto the propeller hub and rear
bulkhead. The spinner and spinner rear bulkhead have been
number coordinated to match the blade cutout openings.
The spinner dome has a forward bulkhead with a flanged hole
that must engage the cylinder (cap) on the front of the
propeller hub. The fit of the forward bulkhead to the cylinder is
to be snug BUT NOT SO TIGHT that excessive force is
required to push it on. If the fit is too tight, sand the inside of
the forward bulkhead flange. If the fit is too loose, apply the
provided Teflon tape to the cylinder. In some cases a
combination of these processes will be required to obtain the
proper fit.
Fasten the spinner dome and blade cutouts to the rear
bulkhead using the supplied screws and nylon washers.
IMPORTANT: Periodically verify that the spinner screws
are tight during the first few hours of operation.
4-4
