Whirlpool WWEB9602IW, Руководство по установке

Страница: 4 / 18

INSTALLATION INSTRUCTIONS
Transport
Transport must be handled by two persons.
Two persons should respectively stand on
two sides of the washing machine and hold
with both hands to transport the washing
machine.
Placing the washing machine correctly
The washing machine must be installed
on firm, flat and slip-proof ground. Do
not place the washing machine on carpeted
or wood covered floor. It is forbidden to
place the washing machine on a ground
platform and rack.
The washing machine must keep a minimum distance of
10 cm away from the wall or the hard reflector on three
sides.
1. On sloping ground 2. On ground platform and rack 3. On uneven ground
Removing transport bolts and base protector
To protect the washing machine during transport, the
internal structure of the washing machine is fastened
with four transport bolts. All the transport bolts should
be removed before use. (If the bolts are not removed,
the washing machine will vibrate vigorously, generate
loud noises and function improperly during spinning.)
1.Loosen the transport bolts (four pieces) with a wrench.
2.Shake the bolts left and right to pull them out.
3.Align the bolt covers with the original bolt holes and
press until they fit.
Please keep the transport bolts safe. They are necessary
to make a move.
Do remove the base protector before use, as shown in
the figure, or the washing machine will function improperly.
MATTERS NEED ATTENTION
1.Items that have been soiled with substances such as cooking oil,
acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes
and wax removers should be washed in hot water with an extra
amount of detergent before being dried in the tumble dryer.
2.Items such as foam rubber (latex foam), shower caps, waterproof
textiles, rubber backed articles and clothes or pillows fitted with
foam rubber pads should not be dried in the tumble dryer.
3.Fabric softeners, or similar products, should be used as specified
by the fabric softener instructions.
4.Remove all objects from pockets such as lighters and matches.
5.Fill steam generators only with liquids specified by the
manufacturer.
6.WARNING: Never stop a tumble dryer before the end of the drying
cycle unless all items are quickly removed and spread out so that the
heat is dissipated.
7.WARNING: The appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by a utility.
8.For appliances with ventilation openings in the base, instructions
that a carpet must not obstruct the openings.
9.Exhaust air must not be discharged into a flue which is used for
exhausting fumes from appliances burning gas or other fuels.
10. The appliance must not be installed behind a lockable door, a
sliding door or a door with a hinge on the opposite side to that of
the tumble dryer, in such a way that a full opening of the tumble
dryer door is restricted.
3. Tighten the locking nuts counterclockwise with the
wrench to lock the nuts to the bottom of the case.
4. After adjustment, press the diagonal corners of the top
cover of the washing machine by a proper force with two
hands to confirm that the washing machine is stable.
Case
2
.
1
.
3
.
①
②
4
.
Level adjustment
If installed on an uneven place, the washing machine will
generate abnormal noises or vibrations or function
abnormally when in use.
The feet of the washing machine (the four feet are all
adjustable) can be adjusted by the following method:
1. Loosen clockwise the locking nuts of the washing machine
feet with the wrench and rotate the feet to adjust the height
so as to make the washing machine level.
2. When allowed by conditions, use a level meter to check
the adjusted state of the washing machine and make
calibration when necessary.
Note: all four feet must reliably touch the ground and stand
on the ground firmly.