You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
• Visiting our website -
docs.indesit.eu
• Using QR Code
• Alternatively,
contact our After-sales Service
(See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product’s identifi cation plate.
THANK YOU FOR BUYING A INDESIT PRODUCT.
In order to receive a more complete assistance,
please register your product on
www.indesit.eu/register
EN
Quick guide
Before using the appliance carefully read the Safety Instructions.
xxxxxxxxxxxx
xxxx
Before using the appliance carefully read the Safety Instructions.
xxxxxxxxxxxx
xxxx
Heat Pump System
The heat pump contains fluorinated greenhouse gases,
contained in a hermetically sealed unit. This sealed unit contains
0,18 kg of the F gas R134a. GWP = 1430 (1 t CO2).
Power consumption
off-mode (Po) - Watts
0.50
left-on mode (Pl) - Watts
1.00
Programs
Kg
kWh
Minutes
Eco Cotton *
9
2.07
211
Eco Cotton
4.5
1.20
131
Synthetics
4
0.73
95
*Test programme according to AS/NZS 2442.2 standard. Tested with
maximum rated load capacity and dryness level Extra Dry.
TRANSPORT AND HANDLING
Never lift the dryer by holding it at the worktop.
1. Unplug the dryer.
2. Make sure that door and water tank are properly closed.
3. If the drain hose is connected to your sewage system, fix the
drain hose on the rear of the dryer again (see Installation Guide)
.
A
B
1
4
2
3
C
CARE AND MAINTENANCE
Unplug the dryer during the cleaning and maintenance
procedures.
Emptying the water tank after each cycle (see Fig. A).
Pull the container out of the dryer and and empty it into a
sink or other suitable drain, then place it back. Do not use the dryer
without having inserted the container back in place.
Cleaning the door filter after each cycle (see Fig. B).
Pull the filter out and clean it by removing the lint from the
filter surface under running water or using a vacuum cleaner. For
optimal performance, dry up all the filters before inserting them
back in place. Do not use the dryer without having reinserted the
filter in place.
Remove the door filter as described below:
1. Open the door and pull upwards.
2. Open the filter and remove lint from all its parts. Replace it
correctly.
Ensure it is completely inserted flush with the dryer seal.
Cleaning the bottom filter when the relevant indicator
turns on (see Fig. C).
Pull the filter out and remove the lint from its surface by washing
it under runing water or by using a vacuum cleaner.
However, it is advisable to clean this filter after each cycle to
optimise drying performance. Do not use the dryer without
having inserted the filter in place first.
Remove the bottom filter as described below:
1. Open the lower door.
2. Take the handle and pull the lower filter out.
3. Open the rear side of the filter and remove the lint from the
inner surface of the mesh.
4. Clean the bottom filter chamber avoiding the direct contact
with the leaves.
5. Close the rear side of the lower filter and place it back by
checking it is perfectly integrated in place.
6. Lower the filter handle and close the bottom door.
7. Make sure the air intake is free.
The filters are essential parts for drying. They are intended
to collect the lint formed during drying process. In case
of clogged filters, the air flow inside the dryer would be
seriously affected: the drying times would be longer, the
energy consumption would increase and the dryer could be
damaged. If these procedures are not carried out properly,
the dryer may not start.
PRODUCT DESCRIPTION
1.
Water Tank
2.
Air Intake
3.
Bottom filter
4.
Door filter
