Whirlpool WFC8090GX, Руководство по обслуживанию, Страница: 63 / 82

COMPONENT ACCESS
Whirlpool Smart All-In-One Washer & Dryer
n
4-11
Removing the Detergent Dispenser
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
To Remove the Detergent Dispenser
1. Unplug washer/dryer or disconnect power.
2. Turn off water supply to washer/dryer.
3. Disconnect cold inlet water hose and remove the drain
hose from the standpipe or laundry tub.
4. Perform the procedures on page 4-3, “Removing the Top
Panel” prior to performing the following steps.
5. Perform the procedures on page 4-6, “Removing the Front
Panel” prior to performing the following steps.
6. Perform procedure “6” on page 4-10, “Removing the
Metering Pumps” prior to performing the following steps.
7. For ease of dispenser removal, take out the “T” shaped”
cross-brackets by removing eight (10) Phillips screws.
NOTE : Eight screws secure the “T” bracket to the cabinet
and 2 to the dispenser.
8. Remove the remaining 4 screws, illustrated in Figure 1,
securing the dispenser to the washer/dryer.
9. Disconnect the black (dispenser) hose from the inlet valve.
See Figure 1.
Screws Removed
in Step “6”
Black Hose
Figure 1
10. Lift up the dispenser assembly. From the front left of the
washer/dryer, remove the large “dispenser to tub” hose.
See Figure 2.
11. Next remove the medium tub hose (medium front hose to
tub). See Figure 2.
Large
Hose
Medium
Hose
Figure 2
12. Lift dispenser assembly and remove from washer/dryer.
13. Reverse procedure to reinstall dispenser.