W10198668B
.
O
N
T
R
A
P
Y
L
N
O
E
S
U
S
’
N
A
I
C
I
N
H
C
E
T
E
C
I
V
R
E
S
R
O
F
TECH SHEET - DO NOT DISCARD
PAGE 10
2.
Slide the bracket over the top of the drum
to access the machine control electronics
connectors and mounting screw. See figure 17.
3.
Remove all the wire connections to the
machine control electronics. See figure 18.
4.
Remove the screw holding the machine control
electronics assembly to the mounting bracket.
See figure 17.
5.
There are two plastic legs on the front of the
machine control electronics that slide under the
mounting bracket.
There is one plastic leg on the rear of the
machine control electronics that slides
under the mounting bracket.
There is a locking tab on the bottom of the
machine control electronics that snaps into
the mounting bracket.
Press the locking tab on the bottom of the
machine control electronics and slide the
assembly to the front, then lift.
3.
Gently remove the decorative trim that
surrounds the door and upper console by
unsnapping it from the dryer. See figure 20.
4.
Slide the console up and off of the dryer.
See figure 19.
5.
The console mounting bracket is fastened to
the console front panel with two latches at both
sides of the console assembly. Unlatch the
bracket gently with a screwdriver while pulling
the mounting bracket assembly out. See
figure 19.
6.
The console electronics is split into two
assemblies connected by two cables. Each
assembly is fastened to the decorative piece
by four plastic latches. To remove these
assemblies, gently compress the plastic
latches while pulling up on the assembly. For
the cycle selector assembly, the cycle selector
knob must first be removed by firmly pulling
on it or gently prying it straight upward. See
figure 21, page 11.
Console Electronics and Housing
Assembly
The console panel must be removed to access the
console electronics and housing assembly.
1.
Perform steps 1 and 2 under Accessing &
Removing the Electronic Assemblies, page 9,
and disconnect the P2 and P5 harnesses from
the machine control.
2.
Remove the screw that fastens the assembly
to the machine control mounting bracket
(figure 17), and the two screws that fasten the
console assembly to the dryer (figure 19).
P9
1
5
1
P14
P2
3
1
1
6
1
1
8
3
P5
P3
1
P13
1
P/N
XXX
XXX
Rev
X
Date
Code
YDD
D-xx
XXX
X-X
XX
MAD
EIN
COO
N.O.
Black
COM
Red
Heater
Relay 1
Motor
Relay
Black-White
White
Green-Yellow
Brown
Lt. Blue Black
Yellow-Red
Open (Gas)
Black (Gas)
Red-White (Gas)
P4
N.O.
Blue
Water Valve
Relay
COM
Red
P8
Figure 18.
Machine control electronics.
Figure 20.
Remove the decorative trim.
Machine Control Electronics
Bracket Screws
FRONT
Machine Control
Electronics Mounting Screw
Figure 17.
Remove machine control electronics
from mounting bracket.
Figure 19.
Remove the console panel to access
the console electronics and housing assembly.
Tan
