4
■
Pour rinse aid into the opening until the indicator level shows
that it is full.
■
Close dispenser by pushing down gently on the lid.
NOTE:
For most water conditions, the factory setting will
give good results.
If you are experiencing poor drying performance, you may
want to try a higher setting. Turn the arrow adjuster to a
higher setting to increase the amount of rinse aid.
5.
Select a Cycle
Efficient dishwashers run longer to save water and energy, just as
driving a car slower saves on gas. Typical cycle time is approximately
2
¹⁄₂
hours but can take less or more time to complete, depending
on selections.
6.
Select Options
You can customize your cycles by pressing the options desired. If you
change your mind, press the option again to turn off the option. Not all
options are available for every cycle. If an invalid option is selected for a
given cycle, the lights will flash. Adding options may increase the cycle
time displayed.
7.
Follow the Progress of Your Dishwasher
The fully lit display will glow for Wash, Drain,
Drying, Sanitized, and Complete. It will also
display the remaining time for the cycle in
hours and minutes.
Select the desired cycle by pressing the
Cycles button. Each time the Cycles button is pressed, the next
available cycle will be displayed.
8.
Start or Resume a Cycle
NOTE:
Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
IMPORTANT:
If anyone opens the door to add a dish (even during
the Delay Hours option), the START/RESUME button must be pressed
each time.
■
Push door firmly closed within 3 seconds of pressing START/
RESUME. If door is not closed within 3 seconds, the Start/Resume
button LED will flash, an audible tone will be heard, and cycle will
not start.
Estimated cycle times may increase or decrease, depending on water temperature, soil conditions, dish load size, and options selected.
SLIDE
Full
Add
CYCLES
SOIL LEVEL
ESTIMATED
WASH TIME
DISPLAYED*
H:MM W/O
OPTIONS
WATER
USAGE
GALLONS
(LITERS)
The most advanced and versatile cycle. This cycle senses load size, soil
amount, and toughness of soil, to adjust the cycle for improved performance,
using only the amount of water and energy needed. Use for all soil levels.
All soil levels
2:30
3.38 to 7.4
(12.8 to 28.0)
Use for hard-to-clean, heavily soiled pots, pans, casseroles, and tableware.
Heavy
3:23
7.4 (28.0)
This cycle with only the Heat Dry option selected, and without other options
selected, is recommended to completely wash and dry a full load of normally
soiled dishes. The energy usage label is based on this cycle and option
combination.
All soil levels
2:21
2.4 to 7.4
(9.09 to 28.0)
Use for lightly soiled items. It saves energy.
Light
2:21
2.72 (10.29)
For fast results, 1-Hour Wash will clean dishes using slightly more water and
energy. For improved drying, select the Heat Dry option.
NOTE:
Some detergents are not recommended for short wash cycles, please
refer to your detergent packaging for more information.
Light
1:00
7.87 (29.8)
CYCLE GUIDE
