ACTIVATING THE MANUAL LOAD TEST
FOR SERVICE TECHNICIAN ONLY - DO NOT REMOVE OR DESTROY
PAGE 7
1.
Be sure the dryer is in standby mode (plugged
in with all indicators off, or with only the Done
[Whirlpool models], Dry [Maytag models], or
Clothes Dry [Amana models] indicator on).
2.
Select any one button (except Pause/Cancel
and Controls Lock/Unlock [Whirlpool models],
Control Lock, Start/Pause, and Power/Cancel
[Maytag models], or Stop and Cycle Signal
[Amana models]) and follow the steps below,
using the same button (remember the button):
a.
Press/hold 2 seconds.
b.
Release for 2 seconds.
c.
Press/hold 2 seconds.
d.
Release for 2 seconds.
e.
Press/hold 2 seconds.
f.
Release for 2 seconds.
g.
Press/hold 2 seconds.
Steam Models Only:
The motor starts right away, the “Steam”
(Whirlpool models) or “Sensing” (Maytag models)
Status LED comes on, and “0” (zero) is displayed
(this step starts the Manual Load sequence):
“Steam” (Whlpl)
1. Motor turns
or “Sensing”
0:00 is
on.
(Maytag) Status
displayed.
LED turns on.
Now press any key (except Pause/Cancel
and Controls Lock/Unlock [Whirlpool models]
or Power/Cancel [Maytag models]) and the
control will advance through each step
of the following sequence:
2. Motor +
“Wet” Status
0:01 is
heater
LED turns on.
displayed.
3. Motor +
“Damp” Status
0:02 is
LED turns on.
displayed.
water valve.
4. Motor +
“Cool Down”
Status LED
0:03 is
water valve +
turns on.
displayed.
drum light.
“Done”
5. All loads
(Whlpl) or
0:04 is
turn off.
“Dry” (Maytag)
displayed.
Status LED
turns on.
Non-Steam Models Only:
The motor starts right away, the “Sensing” Status
LED comes on, and “0” (zero) is displayed (this
step starts the Manual Load sequence):
1. Motor turns
“Sensing” status
0:00 is
on.
LED turns on.
displayed.
Now press any key (except Pause/Cancel
and Controls Lock/Unlock [Whirlpool models],
Power/Cancel [Maytag models], or Stop and
Cycle Signal [Amana models]) and the control
will advance through each step of the
following sequence:
2. Motor +
“Damp” Status
0:02 is
heater
LED turns on.
displayed.
3. Motor +
“Cool Down”
0:03 is
Status LED
displayed.
drum light.
turns on.
“Done” (Whlpl),
“Dry” (Maytag),
4. All loads
or “Clothes Dry”
0:04 is
turn off.
(Amana) Status
displayed.
LED turns on.
Press the Pause/Cancel (Whirlpool models),
Power/Cancel (Maytag models), or Stop (Amana
models) button to exit this mode.
DEACTIVATING THE MANUAL
LOAD TEST
