4
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Tools needed for connecting the water inlet hoses
Pliers (that open to 1
9⁄16
" [39.5 mm])
Flashlight (optional)
Tools needed for installation
Open end wrenches 13 mm and 12 mm
Level
Wood block
Ruler or measuring tape
Parts supplied
Alternate Parts
Your installation may require additional parts. If you are interested
in purchasing one of the items listed here, call the toll-free
number on the cover or in the “Assistance or Service” section.
Options
Pedestal
You have the option of purchasing a pedestal for this washer. You
may select an 11.8" (30.0 cm) pedestal. The pedestal will add to
the total height of the washer.
Optional pedestal
Stack Kit
Are you planning to stack your washer and dryer? To do so you
will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your washer
or refer to the “Assistance or Service” section. Ask for Part
Number W10178021.
Location Requirements
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer “walk.”
Your washer can be installed under a custom counter, or in a
basement, laundry room, closet, or recessed area. See “Drain
System.”
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
A water heater set to deliver 120°F (49°C) water to the washer.
A grounded electrical outlet located within 5.4 ft (1.65 m) of
where the power cord is attached to the back of the washer.
See “Electrical Requirements.”
Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water
fi
ll valves, and water pressure of
20-100 psi (137.9-689.6 kPa).
A level
floor
with a maximum slope of 1" (2.5 cm) under entire
washer. Installing the washer on soft
fl
oor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
A sturdy and solid
fl
oor to support the washer with a total
weight (water and load) of 400 lbs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.
A. U-shaped hose form
B. Water inlet hoses (2)
C. Inlet hose washers (4)
D. Beaded cable tie
If You Have
You Will Need to Buy
Laundry tub or
standpipe taller
than 55" (1.4 m)
Sump pump system (if not already
available)
Overhead sewer
Standard 20 gal. (76 L), 30" (76.2 cm) tall
drain tub or utility sink and sump pump
(available from local plumbing suppliers)
Floor drain
Siphon break, Part Number 285834;
additional drain hose
Part Number 8318155; and connector kit,
Part Number 285835
Drain hose too
short
4 ft (1.2 m) drain hose extension kit,
Part Number 285863
Water faucets
beyond reach of
fi
ll
hoses
2 longer water
fi
ll hoses:
6 ft (1.8 m) Part Number 76314
10 ft (3.0 m) Part Number 350008
A
B
C
D
Pedestal
Height
Approximate
Height with
Washer
Color
Model
Number
11.8" (30.0 cm)
44.7" (113.5 cm)
White
LAB0050PQ
