18
3. Remove the 2 screws that hold the handle bracket to the
door.
4. Move hinge to the other side and reattach with the 4 screws
removed in Step 2.
5. Move handle bracket to the other side and reattach with the
2 screws removed in Step 3.
6. Set the inner door assembly aside.
Reinstalling the door
1. Check for fingerprints on the glass. Clean if necessary.
2. Place the inner door assembly into the outer door assembly.
Align the hinge in the opening on the side. To fit correctly, the
inside door assembly edge is completely inside the outside
door assembly edge.
3. Reassemble the inner and outer door assemblies with the
6 screws.
4. Replace the 2 handle screws for the door handle of the door
assembly.
5. Remove the plug strip or label.
Style 1: Remove the plug strip.
■
Use a small flat-blade screwdriver to remove the plug
strip in the door opening. Slide the head of the
screwdriver under the top portion of the plug strip, being
certain not to scratch the dryer surface. Lift up. Repeat in
the middle and at the bottom. Remove the plug strip in
the door opening and insert in the opposite side.
Style 2: Remove the label.
■
Peel off the label located on the opposite side of the door
opening covering the hinge mounting holes. Apply the
label over the original hinge holes.
6. Insert a screw in the second opening from the top of the
hinge opening and partially tighten. Hang the door by placing
the top hinge keyhole over the second screw head and
tighten the screw. By putting this screw in first, the door will
hang in place while you insert and tighten the remaining
4 screws.
7. Close the door and check that it latches securely.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. Check the dryer’s final location. Be sure the vent is not
crushed or kinked.
5. Check that the dryer is level. See “Level Dryer.”
6. In the U.S.A.
■
For power supply cord installation, plug into a grounded
outlet. For direct wire installation, turn on power.
In Canada
■
Plug into a grounded 4 prong outlet. Turn on power.
7. Remove any protective film or tape remaining on the dryer.
8. Read “Dryer Use.”
9. Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
10. Set the dryer on a full heat cycle (not an air cycle) for
20 minutes and start the dryer.
If the dryer will not start, check the following:
■
Controls are set in a running or “On” position.
■
Start button has been pushed firmly.
■
Dryer is plugged into a grounded outlet and/or electrical
supply is on.
■
Household fuse is intact and tight, or circuit breaker has
not tripped.
■
Dryer door is closed.
A. Dryer door
B. Dryer
C. Insert this screw first.
A
B
C
