Whirlpool LHB 802, Руководство по обслуживанию, Страница: 26 / 34

_______________________________________________________________________________________
Page | 26
RID#1 .6 SUPERSOAK
1. Super soak option selection improves the Wash performance whenever
the dirt level in the Wash loads found to be higher.
RID#1 .7 DELAY END
1. Delay End key is used to set the “Delay End” time for the selected wash
program
RID#2 ERROR DISPLAY & ITS DIAGNOSIS
RID#2.1 CHECK WATER ERROR
1. If desired water level did not attain within 10 mins during fill then Check Water Error will
be popped by means of turning ON the Check water LED.
2. Inlet valve will move to OFF state after 5 mins from Check water error detection & waits
for start key press after checking the water inlet.
3. Need to check:
a.
Ensure the Water supply at the inlet.
b. Check for the blockage at fill hose and at the Inlet valve filter.
c. Ensure that Inlet valve is turning ON during fill process and if
not check for inlet valve operation & its connections from PCB to Inlet valve.
d. Check for pressure sensor frequency response & kink or puncture at the pressure
hose.
e. Ensure that drain hose free end should be left in atmosphere not in any other
medium.
f. Ensure that the Water head is >10ft from the Machine Inlet.
RID#2.2 DRAIN ERROR
1. If the water in the system fails to drain within 4 mins from the start of drain process
“dE” error will be popped with water level group LEDs blinking
2.
Need to check:
a. Ensure that drain hose should not be elevated for more than
20cms from the ground level
b. Ensure that Torque Motor is turning ON during drain process and if not check for
Torque Motor operation & its connections from PCB to drain pump.
c. Check for any kink or blockage at drain hose.
d. Ensure that drain hose free end should be left in atmosphere
not in any other medium.
e. Check for pressure sensor frequency response.