Whirlpool Gold GU2800XTV, Руководство пользователя

Страница: 62 / 75

6-5
Continued on the next page
Detergent carryover. Check water hardness. If below 10 grains, then
instruct customer to use less detergent and
recommend the High Temp option.
Drain loop check valve not
sealing.
1. Disconnect drain hose at plumbing connection.
2. Elevate hose above dishwasher and fill with
water. If water flows into dishwasher, replace
entire drain loop (install as high as possible and
attach to underside of countertop if possible).
Poor Dry
Customer not using rinse aid
and/or Heated Dry.
Recommend use of rinse aid and Heated Dry.
Instruct customer how to fill and monitor rinse aid.
Line voltage too low to heat fast
enough.
Check power source. Confirm at least 100 VAC.
Rinse Aid dispenser not
dispensing.
See last three items under “Detergent Not
Dispensing or Detergent Left in Dispenser.”
A heating problem could cause
poor drying but will typically
cause a water heating fault.
Refer to “Service Error Codes” table.
7-1
Diverter problem prevented water
from heating.
Refer to “Service Error Codes” table.
NOTE: Refer to table even if error code not
recorded by control.
4-1
4-4
Control canceled cycle due to
error detected with wash motor,
low water, or suds.
Refer to “Service Error Codes” table.
6-1
6-2
8-1
Sanitized LED
Blinks at the End of
a Cycle (Control
Could Not Confirm
Sanitization
Achieved)
Door opened during final rinse or
dry.
Instruct customer.
Incoming water too cold. Refer to “Service Error Codes” table.
8-2
8-3
Line voltage too low to heat fast
enough.
Check power source. Confirm at least 100 VAC.
Diverter problem prevented water
from heating in final rinse.
Refer to “Service Error Codes” table. 4-1
4-4
A heating problem could cause
the temperature not to reach but
will typically cause a water
heating fault.
Refer to “Service Error Codes” table.
7-1
Thermistor/OWI problem. Refer to “Service Error Codes” table. 3-1
3-2
Melted or Etched
Dishware (Long
and/or Hot Cycles)
Customer uses non-dishwasher
safe dishes or loads directly over
heater.
Instruct customer.
Temperature sensing problem. Refer to “Service Error Codes” table. 3-1
Water heating problem. Refer to “Service Error Codes” table.
7-2
Etching can be a result of using
too much detergent.
Instruct customer.
Noisy Operation
Spray arm stalled or blocked and
spraying on the door.
Instruct customer if blocked.
Check spray arm rotation and inspect for
plugged nozzles. If plugged, clean nozzles and
confirm filters installed properly.
Diverter problem. Refer to “Service Error Codes” table. 4-1
4-4
No or low water. Refer to “Service Error Codes” table.
8-1
Drains too long because of
sensor problem.
Refer to “Service Error Codes” table. 3-1
3-3
9-1
Film on Glasses
and/or Dishes
(continued)
CUSTOMER
DESCRIPTION
POTENTIAL CAUSES
CHECK
RELATED
ERROR
CODE(S
)