Whirlpool GAS FURNACE, Инструкция пользователя

Страница: 4 / 12

4
GAS FURNACE OPERATION
Thermostat Control There are many types and styles of thermostats. Your thermostat
may look different from the one shown, depending on the type of
thermostat and whether cooling was installed with the system.
However, almost all thermostats perform the same basic
functions.
There are 2 switches located on the thermostat. One switch
controls the heating and cooling (if applicable) functions. The
other switch is for FAN operation, either continuous or automatic.
Also on the thermostat is the temperature range for the desired
heating and cooling temperatures.
Light Furnace
1. Set the thermostat control(s) to the lowest setting.
2. Disconnect power.
3. Remove the burner access panel (on some models).
4. This appliance is equipped with an automatic ignition device.
Do not try to light the burners by hand.
Gas Control
5. Place the gas control in the ON position.
6. Replace the burner access panel (on some models).
7. Reconnect power.
8. Set the thermostat to the desired setting.
9. If the furnace will not operate, see “Shut Down” and call a
qualified person.
A. Selector switch
B. Room temperature C. Fan switch
D. Heating & cooling temperature setting
ON
A
U
T
O
50
60
80
70
60
50
70
80
A
B
D
FAN
C
WARNING
Explosion Hazard
Furnace must be installed and serviced by a
qualified person.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel.
Read and follow all instructions provided for
installation, adjustment, service, alteration, or
maintenance.
Failure to follow these instructions can result in death,
explosion, fire, or carbon monoxide poisoning.
A. Gas control
OFF
ON
A
A
A