8
REFRIGERATOR CARE
Clean the Refrigerator
Clean the refrigerator about once a month to prevent odors from
building up. Wipe up spills immediately.
IMPORTANT:
The semiautomatic defrost button is located in the
center of the exterior refrigerator control. Once pressed, the
defrost cycle cannot be interrupted. If you inadvertently start the
defrost cycle, follow the instructions in “Defrost and Clean the
Freezer.”
Interior
1.
Unplug refrigerator or disconnect power.
2.
Remove all removable parts from inside, such as shelves,
crispers, etc.
■
Remove the interior defrost tray by pulling it straight out.
■
Replace the interior defrost tray by pushing in and locking
it into place.
3.
Hand wash, rinse, and dry removable parts and interior
surfaces thoroughly. Use a clean sponge or soft cloth and a
mild detergent in warm water.
■
Do not use abrasive or harsh cleaners such as window
sprays, scouring cleansers, flammable fluids, cleaning
waxes, concentrated detergents, bleaches or cleansers
containing petroleum products on plastic parts, interior
and door liners or gaskets. Do not use paper towels,
scouring pads, or other harsh cleaning tools. These can
scratch or damage materials.
■
To help remove odors, you can wash interior walls with a
mixture of warm water and baking soda (2 tbs. to 1 qt.
[26 g to .95 L] of water).
4.
Replace the removable parts.
5.
Plug in refrigerator or reconnect power.
Condenser coils and defrost pan
Clean the condenser coils regularly. Coils may need to be
cleaned as often as every other month. This may help save
energy.
1.
Unplug refrigerator or disconnect power.
2.
Pull refrigerator out away from the wall (see “Unpack the
Refrigerator”).
NOTE:
There may be water in the defrost pan. Move the
refrigerator slowly to avoid spilling water onto the floor.
3.
Vacuum the coils when they are dusty or dirty.
4.
Clean the defrost pan and valve occasionally as needed.
■
Remove the defrost pan and valve as shown.
■
Clean them using a clean sponge or soft cloth and a mild
detergent in warm water. Hand wash, rinse, and dry
thoroughly.
■
Check the defrost drain to be sure it is clear.
■
Replace the defrost pan and valve.
5.
Plug in refrigerator or reconnect power.
6.
Roll the refrigerator back into place. Make sure to leave 3 in.
(7.5 cm) between the cabinet back and the wall.
7.
Check to see if the refrigerator is level.
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion,
or fire.
