Whirlpool ADP 6940 IXM, Руководство по обслуживанию

Страница: 3 / 17

S E R V I C E
Whirlpool Europe ADP 6940 IXM 23.10.2006 / Page 3
Customer Service 8542 940 53930 Doc. No: 4812 728 12449
Technical data
Spray arms, turning rhythm at alternating spray
system
Turning starts every time with the upper spray arm
Pre wash Lower arm ~3min, Upper arm ~1min
Main wash Lower arm ~3min, Upper arm ~5min
Intermediate rinse
Lower arm ~2min, Upper arm ~2min
Final rinse Lower arm ~2min, Upper arm ~2min
Service Test program
Lower arm ~30sec, Upper arm ~30sec
Remark: When switching of the main switch or
interrupt the mains during the Test Program runs,
then the alternating of the spray arms change in
the test program to the rhythm of main wash 5/3
min.
Important: To leaf the Test program is possible by
made a break by customer (pushing the start
button for 1.5 sec.)
After finishing the test program (End LED shines
and/or Start LED goes of) must the appliance be
switched off.
If this will not be done, then the next normal wash
will be made with the frequency of the Service
Test Program ~30/30sec.
Flow rates/ Inlet volume
Flow meter (at 0.3 bar
= quantity 1.1 l/min)
208 lmp/l
Spray pump 45 - 65 l/min
Drain pump 16 l/min
Pump height max. 1.1 m
Inlet valve 4 l/min
Spray arm lower ~ 33 l/min
Sprayarm upper ~ 27 l/min
Shower/ Sprayarm top ~ 8 l/min
Electrical base data
Voltage 240 V
Frequency 50 Hz
Total power 2.4 kW
Fuse 10 A
Spray pump motor alternating spray system
Voltage 220/ 240 V
Power consumption 125 W
HI 79
Ω
HA 60
Ω
Capacitor 4
µ
F
Drain pump motor
Voltage 220/ 240 V
Power consumption 30 W
Resistance 146
Ω
Heating - 1 Element system
Voltage 240 V
Power consumption 2.22 kW
Resistance 24.5
Ω
Heating speed ~ 2.0 ˚C/min
Temperature on surface ~ 115 ˚C
Safety thermostat self reset
(Temperature of water)
~ 85 ˚C
Fuse 206 ˚C
Single electric water inlet valve
Voltage 220/ 240 V
Frequency 50/ 60 Hz
Resistance 3.76 k
Ω
Motor Diverter Valve
Voltage 220 - 240 V
Frequency 50/ 60 Hz
Resistance 6.5 k
Ω
Signal (2x within ~13 sec.) 5.0 V
Coil of dispenser
Voltage 220/ 240 V
Frequency 50/ 60 Hz
Resistance 1.3 k
Ω
Reed contacts
flow meter
rinse aid control
Optical water indicator (OWI)
Optical measurement of the water in sump
Combination part of:
Turbidity sensor
(DON)
Thermostat temp. sensor (notice NTC)