Whirlpool is a registered trademark of Whirlpool USA
5019 396 01682
GB
ADG 9190
Quick Reference Guide
Before using the dishwasher, read the user instructions!
WH/I/FD/GB
(We reserve the right to make technical modifications)
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
“Delayed start” button
The wash cycle can be programmed
to start after 3-6-9 hours.
Then press the Start button.
The wash programme will start at
the set time.
1)
Reference programme for energy label in compliance with
EN 50242 regulations.
2)
Refer to “User instructions”.
3)
The data relevant to programmes are values obtained in
the laboratory in conformity with Standard EN 50242. In
practice there may be time variations or leaps depending
on different loads, function options, sensor calibration (only
for sensor-controlled programmes) water temperatures or
hardness and different power supply voltages.
4)
The bacteria removal efficiency has been tested by the
Institut Pasteur de Lille (France), based on the NF EN
13697 standard of November 2001.
5)
Programme interruption (e.g. the door being opened) may
compromise the result of the antibacterial rinse.
On button
Off button
Programme selection button
Start button
Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Options
3)
Programme chart
Detergent
2)
Consumption
3)
Programmes
Loading instructions
A
B
Litres
kWh
Minutes
AutoSensor
50-65°C
Automatic programme
recommended for routine washes,
with dried-on food (for example for
EN 50242).
X
X
13-19 1.15-1.50 100-130
Quickwash
40°C
Lightly soiled crockery, with no
dried-on food.
X
-
13.0
0.70
30
Eco
1)
50°C
Normally soiled crockery.
Energy-saving programme.
X
X
15.0
1.05
165
Antibacterial
4) 5)
Normally or heavily soiled crockery,
with additional antibacterial action.
X
X
16.0
1.75
120
Intensive
70°C
Recommended programme for
heavily soiled crockery, especially
suitable for pans and saucepans.
X
X
17.0
1.65
145
Important information for Test Laboratories:
For detailed information on the EN/Standard loading comparison test, contact the following address: “[email protected]”.
