10
Clock
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the oven, Timer and Timed Cooking
are off.
1. Press CLOCK.
2. Press the HR or MIN “up” or “down” arrow pads to set the
time of day.
3. Press CLOCK or START/ENTER.
To Disable:
The clock time can be disabled so that it does not show on the
display. To disable, press and hold CLOCK for 5 seconds. To
display the clock time again, press and hold CLOCK for 5
seconds and the time of day will show on the display. The clock
time should not have to be reset.
Tones
Tones are audible signals, indicating the following:
One tone
■
Valid pad press
■
Oven is preheated
■
Function has been entered
Three tones
■
Invalid pad press
Four tones
■
End-of-cycle
■
Reminder, repeating each minute after the end-of-cycle tones
All Tones
All of the above tones are preset on, all except the end-of-cycle
tones can be turned off.
To Turn Off/On: Press and hold STOP TIME for 5 seconds. A
tone will sound and “oFF” or “Snd OFF” (depending on your
model) will appear on the display. Repeat to change back to “on”
or “Snd On” (depending on your model).
Reminder Tones
Reminder tones are four 1-second tones which indicate that the
set time has expired for a timer or a timed oven control function.
To Turn Off/On: Press and hold COOK TIME for 5 seconds. On
some models, “NAG OFF” or “NAG ON” will appear on the
display.
Tone Volume
The volume is preset at high, but can be changed to low.
To Change: Press and hold DELAY START for 5 seconds. A tone
will sound and “HI” or “Snd HI” (depending on your model) will
appear on the display. Repeat to change back to “LO” or “Snd
LO” (depending on your model).
Fahrenheit and Celsius
The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To Change: Press and hold CUSTOM BROIL for 5 seconds. A
single tone will sound. Repeat to change back to Fahrenheit.
Timer
The Timer can be set in hours or minutes up to 12 hours and 59
minutes and counts down the set time. The Timer does not start
or stop the oven.
To Set:
1. Press TIMER SET.
If no action is taken between 1 and 5 minutes (depending on
your model), the display will return to the time of day mode.
2. Press the HR or MIN “up” or “down” arrow pads to set the
length of time.
3. Press TIMER SET or START.
If not pressed within a specific amount of time, the display
will return to the time of day mode and the programmed
function will be canceled.
When the set time ends, end-of-cycle tones will sound, then,
if on, reminder tones will sound every minute.
4. Press TIMER OFF anytime to cancel the Timer and/or stop
reminder tones.
Remember, do not press the OFF pad (button) because the
oven will turn off.
The time can be reset during the countdown by repeating the
above steps.
To display the time of day when the timer is counting down, press
CLOCK.
Control Lock
The Control Lock shuts down the control panel pads to prevent
unintended use of the oven.
When the control is locked, only the CLOCK and TIMER pads will
function.
To Lock/Unlock Control: Before locking, make sure the oven
and Timer are off. Touch and hold START/ENTER for 5 seconds.
A single tone will sound, a padlock icon and “LOCK’D” (on some
models) will appear on the display. The padlock icon will also
appear whenever any command pad is pressed while the control
is locked.
Repeat to unlock. The padlock icon and “LOCK’D” (on some
models) will disappear from the display.
Oven Temperature Control
IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door and element or
burner cycling may give incorrect readings.
The oven provides accurate temperatures; however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit or
Celsius.