AFTER SALES SERVICE
Before contacting After Sales Service:
1.
See if you can solve the problem yourself with
the help of the Trouble-shooting guide.
2.
Switch the appliance on again to see if the
problem has been solved. If it has not,
disconnect the appliance from the power
supply and wait for about an hour before
switching on again.
3.
If the problem persists after this course of
action, contact After-sales Service.
Specify:
•
the nature of the fault,
•
the model,
•
the Service number (the number after the
word SERVICE on the rating plate on the
inside of the appliance),
•
your full address,
•
your telephone number and area code.
Note:
The direction of door opening can be changed.
If this operation is performed by After-sales
Service it is not covered by the warranty.
The door cannot be reversed on models with
front handle.
INSTALLATION
30302009.book Page 67 Monday, February 11, 2008 5:14 PM
• Install the appliance away from heat sources. Installation in a hot place, near heat sources
(radiators, cookers) or direct exposure to the sun will increase energy consumption and should
be avoided.
• If this is not possible, respect these minimum distances:
- 30 cm from coal or oil stoves;
- 3 cm from electric and/or gas cookers.
• For optimum operation, ensure:
- a space of at least 5 cm above the appliance;
- a distance of at least 4 cm from the rear wall;
- place other cabinets at a suitable distance from the appliance to allow at least some air
circulation
• Install the appliance level (adjust the front feet if necessary) in a dry and well-aired place.
• Clean the inside.
• Insert the accessories supplied.
Electrical connection
• The electrical connections must comply with the local regulations.
• Voltage and power input are specified on the rating plate inside the appliance.
•
Regulations require the appliance to be earthed. The manufacturer declines any
liability for injury or damage resulting from failure to observe the above rules.
• If the plug and socket are not of the same type, have the socket replaced by a qualified
technician.
• Do not use extension leads or multi-adapters.
Electrical disconnection
It must be possible to electrically disconnect the appliance by unplugging it or by means of a
double-pole switch installed ahead of the socket.
49
