Whirlpool 6ED22DQXFB01, Руководство по обслуживанию

Страница: 6 / 36

WHIRLPOOL CONSUMER SERVICES
Models 6ED22DQXFW00 6ED22DQXFB01 6ED22DQXFW01
6ED22DQXFB02 6ED22DQXFW02
6ED22DQXFB03 6ED22DQXFW03
Page 6 of 36
MODULAR ICEMAKER SERVICE
Specifications
Mould Heater : 185 W, 286 ohms
Thermostat : Close -8
±
1.5
°
C
Open 0
±
1.5
°
C
Water Fill : 140 ml, 7.5 seconds
Motor : 3 Watts, 16900 Ohms
Module : Stamped circuit, plug-
in connections
Module Test Points
Module Ohmmeter Checks (No
Power to icemaker and ejector blades in park
position)
Test
Points
Compo-
nent Module Position Resist.
Ohms
L-H Mould
Heater Attached to
support 286
L-M Motor Disconnected
from support 16900
Test
Points Compo-
nent Line Voltage 0 Volts
L - N Module Power OK No
power
T - H Bi-metal Open Closed
L - H Heater On Off
L - M Motor On Off
N - V Water
valve On Off
Service Procedures
Cover
Prise plastic pin from right hand side of module
and remove cover.
Module, Motor and Support Assembly
Insert phillips head screwdriver in access ports
in module and remove both screws. Disconnect
shut-off, pull mould from support assembly
Shut-off Arm
Pull out from support. When reassembling
insert to full depth.
Mould and Heater
Remove module, motor and support assembly.
Bi-metal
Remove module and support assembly. Pull
out retaining clips with bi-metal.
Fill Cup
Remove motor, module and support assembly,
remove ejector blades and shut-off arm. Pull
cup from mould.
Ejector Blades and Stripper
Remove module, motor, support assembly.
When reinstalling ejector blades, align “D”
coupling with module cam.
Water Level Adjustment
Turning the screw clockwise decreases the
water fill.
•
1/2 turn equals 20 ml or 1.2 seconds
•
full turn equals 40 ml or 2.4 seconds
•
Maximum adjustment is one full turn in
either direction. Additional rotation could
damage the module.
N
M
H
T L
V
Remove 3
securing
screws