GB4
Cleaning cycle of ovens with pyrolysis function (if present):
This function burns off spatters produced inside the oven during cooking at a temperature of approx. 500°C. At this high temperature, the deposits turn into a light ash
which can be easily wiped away with a damp cloth, when the oven is cool. Do not select the pyrolysis function after every use, only when the oven is very dirty or
produces smoke or fumes while preheating or cooking.
•
If the oven is installed below a hob, make sure that all burners or electric hotplates are switched off during the self-cleaning (pyrolysis) function.
•
Remove all accessories before running the pyrolysis function.
The appliance is equipped with 2 pyrolysis functions:
1.
Energy-saving cycle (PYRO EXPRESS/ECO): which consumes approximately 25% less energy than the standard cycle. Select it at regular intervals (after cooking
meat on 2 or 3 consecutive occasions).
2.
Standard cycle (PYRO): which is suitable for cleaning a very dirty oven.
•
In any case, after a certain number of uses and depending on how dirty the oven is, a message on the oven display advises you to run a self-cleaning cycle.
N.B: during the pyrolysis function, the oven door will not open; it will remain locked until the temperature inside the oven has returned to an
acceptably safe level.
REMOVING THE DOOR
To remove the door:
1.
Open the door fully.
2.
Lift the catches and push them forwards as far as they will go (fig. 1).
3.
Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (fig. 2).
To refit the door:
1.
Insert the hinges in their seats.
2.
Open the door fully.
3.
Lower the two catches.
4.
Close the door.
MOVING THE TOP HEATING ELEMENT (SOME MODELS ONLY)
1.
Remove the side accessory holder grilles (Fig. 3).
2.
Pull the heating element out a little (Fig. 4) and lower it (Fig. 5).
3.
To reposition the heating element, lift it up, pulling it slightly towards you, making sure it comes to rest on the lateral supports.
WARNING
-
Do not touch the oven during the pyrolysis cycle.
-
Keep children away from the oven during the pyrolysis cycle.
MAINTENANCE
WARNING
-
Use safety gloves.
-
Ensure the oven is cold before carrying out the following operations.
-
Disconnect the oven from the power supply.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
